Owner`s manual

Page 25 Bullfrog Spas Owner’s Manual
JETZONES:
Bullfrog Portable Spas powered by two pumps provide
a unique feature called JetZones. A JetZone is a region
of jets that are all powered by the same pump. With
JetZones, you decide which JetPaks are powered by
each pump.
With a two-pump spa you get two JetZones. Each of
these JetZones can be customized with the use of a
JetZone Divider (Fig. T).
By simply moving the JetZone Divider, you can either
increase or decrease the number of JetPaks that are
powered by a particular pump, thus creating a new
JetZone. By adding JetPaks to a particular JetZone you
will decrease the power to that zone. By removing
JetPaks from a particular zone you will increase the
power to that zone.
TO CREATE A NEW JETZONE:
1. Put the spa in "Standby Mode". This will prevent the
pump(s) from activating while disconnecting JetPaks.
(See "Standby Mode" under "OPERATION" in this
Manual.)
2. Locate the JetPak that contains the JetZone Divider.
3. Remove the headrest.
4. Using your hands, remove the SnapCap™ by lifting
it upward.
5. Push the JetPak forward until you have enough
room to reach the two PVC unions.
6. Using your hands, loosen the two PVC unions.
7. Pull the manifold out from between the two unions
and then remove the JetPak from the JetPod.
8. Remove the JetZone Divider (Fig. T) and reattach
the JetPak in the same manner as you removed it.
9. Install the JetZone Divider in a location of your
choice.
Note: If you would like to interchange JetPaks, please
refer to “JetPaks” in this Manual.
IMPORTANT WARNING: Never operate the spa
without the JetZone Divider in place. Doing so, will
cause serious damage to your pump(s).
JetZone Divider
JetPak manifold union
Figure T
Figure T