Owner`s manual

Page 22 Bullfrog Spas Owner’s Manual
2- The amount of water flow may be inadequate. Make
sure the spa is filled correctly.
3- A pressure switch may have malfunctioned. The spa
will continue to operate, but the heater will not
activate. Contact your authorized Bullfrog Spa Dealer.
Flow Switch Failure
If the panel display shows a constant “FLO”, a pressure
switch has malfunctioned. Contact your authorized
Bullfrog Spa Dealer.
Temperature Set Back
When the display shows “COOL”, the spa water is more
than 20°F cooler than the set temperature. The heater
will automatically activate to provide freeze
protection. This is a normal spa function; no
corrective action is necessary.
Freeze Protection
If a freeze condition is detected “ICE” will be displayed
on the panel. The pump(s) will be automatically
activated. This is a normal spa function; no corrective
action is necessary. Freeze protection is enabled
regardless of the spa's status.
High-Limit Sensor Failure (Spa is deactivated.)
When the panel display shows “Sn1” the high-limit
temperature sensor is non-functional. This must be r
epaired only by an authorized Bullfrog Spa Dealer.
Main Sensor Failure (Spa is deactivated.)
If “Sn3”appears on the display, the main sensor is
non-functional. This must be repaired only by an
authorized Bullfrog Spa Dealer.
Standby Mode (Spa is deactivated.)
When “Stby” appears on the panel display, all spa
functions have been disabled except for freeze
control. Press any button on the control pad to reset
the system. The "Standby Mode" is primarily used to
prevent the pumps from being activated while
changing JetPaks, cleaning the filter or cleaning the
skimmer basket.
Warning! Shock Hazard! No User Serviceable Parts.
Do not attempt service of this control. Contact you
authorized Bullfrog Spa Dealer. Follow all Owner’s
Manual power connection instructions. Installation
must be performed by a licensed electrician, and all
grounding connections must be properly installed.