Owner`s manual

www.imperialspaparts.com

Spa Troubleshooting

PROBLEM Possible solution

Control System Problems See Error Messages

Spa Does Not Operate GFCI in supply circuit tripped

No voltage in power supply circuit

High Temperature – Hi limit displayed on the topside

One of the fuses burned out

Water Not Heating Heater not energized adjust thermostat setting to a higher setting

Low Temperature Spa not covered

Ambient temperature too low (below freezing)

Pressure switch malfunction

Filter or filter line clogged

Pressure switch wires possibly loose (“PS1”).

Water temperature sensor open (“TS”)

Heat - temp. sensor opened (“HTS”)

Control Circuit board malfunction

Primary pump cavitating

Primary pump failure

Spa is in “Eco” mode

Poor Water Flow Primary pump not primed

No Water Flow Closed discharge line (if equipped)

Closed suction valve (if equipped)

Air lock in pump or water line

Filter plugged (clean 1-2 times a month)

Water level too low

Impeller clogged or damaged

Suction or discharge line partially closed or clogged

Main 30 amp fuse blown

Motor overheat protection tripped

Jets closed (check all jets)

NOTE:

THE SKILLS AND TOOLS NECESSARY FOR THE SAFE REPAIR OF THIS SPA REQUIRE THE

SERVICES & EXPERTISE OF AN AUTHORIZED SERVICE TECHNICIAN.

Product specifications are subject to change without notice.

Use the installation instructions supplied with this product.