Owner`s manual

www.imperialspaparts.com

Converting to 240VAC (Continued)

An illustration showing proper electrical connections for 240VAC 30/50 Amp service has been

provided for you on a wiring diagram and instructions affixed to the back side of the electrical box

faceplate. You can find GFCI wiring instructions on the back side of the electrical box faceplate

as well. Be sure to follow these and all other instructions carefully. Be sure that all connections

are tight before switching on the circuit breaker. All wiring should be performed by a licensed

electrician.

If the unit is to be permanently connected, connect only to a circuit protected by a ground

fault circuit interrupter (GFCI).

IF THE SPA IS WIRED INCORRECTLY, YOUR WARRANTY IS VOID.

Filter Maintenance

It is important to maintain an unobstructed filtration system. Not only does this provide the spa

with maximum performance for the hydrotherapy jets, but it allows for proper filtration. We rec-

ommend that the filter(s) be cleaned once every two weeks. Remove and soak the filters, to

dissolve minerals submerse the filters in a solution of one part bleach and one part water for a

period of 24 hours. Use a garden hose and squirt water into the center of the filter after the 24

hour soak. Rotate and flush the filter pleats. The water filtration system may become clogged

with particles, debris or calcification that can reduce the water flow. The necessity of filter re-

placements depends on the use the spa receives and the mineral or body oil content. If calcifica-

tion appears on the filter(s), replacement is necessary.

Contact your local dealer or authorized service technician, or call the Customer Service

Hotline at 1-800-393-3399 for replacement parts.

Warning: Do not run the spa without the filter(s) because debris may be

pulled into the pump and cause damage which will void your warranty.

SCREW-IN

TYPE FILTER

FILTER SCREEN

DRAIN HOLE