Owner`s manual

www.imperialspaparts.com

TOPSIDE CONTROL OPERATING INSTRUCTIONS

Warmer

Jets

Jet 1

Economy

Heat

Mode

Cooler

Light

Temperature Controls Buttons

When either of the buttons is pressed once, the display will show the temperature that has

been set. Each time either of the buttons is pressed again, the set temperature will in-

crease or decrease in increments of 1ºF depending on which button is pressed. After 3 seconds,

the display will automatically show the current spa water temperature.

Jets 1 Button

Jet 1

The control panel button designated

Jet 1

activates high speed pump when pressed once. When

the

Jet 1

button is manually pressed again, the low speed pump will be activated. When the pump

is in operation, the LED

Jet 1

is illuminated. (Flashes in low speed)

Note:

After the

Jet 1

button on the topside control is used, the spa will automatically shut down within 20 minutes

of use. After the 20 minutes of use has expired, the jets may be restarted by pressing the

Jet 1

button again.

Light Button

The control panel button designated activates the spa light when pressed. The light has a forty minute

time-out. If the button is pressed again prior to the 40 minute time-out, the light will be deactivated.

Mode Button

Mode

The button designated

Mode

switches the system between Standard and Economy modes. In Standard

mode, the spa will be heated automatically to the set temperature and maintain that temperature. In

Economy mode, the heater is disabled, but the

Jet 1

, and buttons can be activated. In Economy mode,

the LED light above the mode button on the topside control will be lit.