Owner`s manual

www.imperialspaparts.com

Spa Equipment System

Two Speed Pump

The control system includes a two speed pump that provides hydrotherapy jet action while oper-

ating in high speed. The same pump works in low speed along with heater and the ozone gen-

erator (if equipped) to filter and sanitize the water (please see page 19 for sanitizing instructions).

Heater

Your spa is equipped with an electrical heater. By setting your thermostat to the desired tempera-

ture, your heater along with the low speed pump will automatically turn on and off to maintain the

set temperature. This is not only convenient, it is also energy efficient. The spa will maintain the

water temperature as required and does not depend on the filtration cycle to heat.

Please note:

The spa comes from the factory equipped with a 120 VAC 15(20) Amp line cord. The heater will

not operate in conjunction with the high speed jets when installed with a 120 VAC service. Con-

verting the spa to 240VAC (50 Amp) will allow the heater to work at the same time as the high

speed pump and will heat 3-4 times as quickly.

Digital Topside Control

Your spa is equipped with a Digital Topside Control located on the top of the spa. The Topside

Control provides all control functions of the spa equipment (pumps, light, heater). For more de-

tails follow the TOPSIDE CONTROL OPERATING INSTRUCTIONS (page 8) and CONTROL

FEATURES (page 12).

Ozone Generator

Ozone generator (if equipped) injects ozone into the spa water during the (low speed) filtration

cycle. Ozone is injected into the water to supplement chemical sanitizers, kill bacteria, and oxi-

dize organisms. The ozone generator will help to reduce the amount of chemicals needed to

keep the spa sanitary and clean. Anytime the jet pump (high/low speed) is turned on when the

spa is in the filtration cycle, the ozone generator will turn off and will remain off until the next

filtration cycle.