Owner`s manual

MAX STEREO SYSTEM / SPA THEATER SYSTEM (STS)
LSX 850 STS, LSX 825 STS, LSX 1000 STS and LSX 1050 STS
Note: We have included the stereo and DVD owner’s manual with your spa. This should be read to see the
specific operation of these components.
Note: Do not place wet DVD’s or CD’s into the players at any time. Resulting damage will not be covered
under warranty.
System includes a 19" flat screen color television, DVD player, Kenwood CD/FM Stereo system with
subwoofer, and two pop up marine grade speakers (4 on some models), two exterior speakers, water
resistant Dolphin remote, and one touch up and down for TV and speaker housing.
58
DO NOT DIVE.
The TV and pop up speakers can be raised and lowered by pressing the one touch up and down STS
auxillary button. Be sure the TV and speakers are down before placing the cover on the spa. Resulting
damage is not covered under warranty if the cover is installed while the TV and speakers are still in the
upright position.
Note: The television communicates with the wireless remote via IR. Please note that the IR is a line of
sight communication method and the range and functionality can be compromised by sunlight and
other wireless communications interferences that are not controlled by Master Spas.
INSTALLATION INSTRUCTIONS
1. Put spa in final position that allows for access to equipment and spa components.
2. Remove front side panel (This is the side where the main topside control panel is located) so
electrical can be hooked up to the spa system pack. Panels are removed by unscrewing the screws
in the corner sections and then lifting up the panels out of the retaining tracks. NOTE: If your spa is
equipped with Master Select panels, you will need to remove the Phillips mounting screws instead
of the corner screws.
19
DO NOT DIVE.
3. Be sure all pump and heater unions are secure. Each pump has 2 unions and the heater has
2 unions. A newly delivered spa may have loose unions caused in transporting the spa. Check
that all slice valves are open, in the up position. Again, the slice valves may become closed during
transportation of the spa.
4. Fill spa at least 1" above the filters. We recommend filling the spa through the filter area.
5. Turn the power on to the spa. Spa will go through its priming mode. This lasts approximately
5 minutes.
6. Be sure the jets in your spa are open by turning the face of the jet.
Note: The Master Blasters are only turned on/off through the use of the “Jets 3” button or the
diverter valve (if equipped).
Slice Valve
and Pump Union