Owner`s manual

America’s Leader In Luxury
MASTER SPAS
56
DOWN EAST AND FREEDOM - SINGLE PUMP SYSTEM
Mode
Mode is changed by pressing the "Temp" button, then pressing the "Light" button.
Standard Mode is programmed to maintain the desired temperature. Note that
the last measured spa temperature displayed is current only when the pump has
been running for at least 2 minutes. "St" will be displayed momentarily when you
switch into Standard Mode.
Economy Mode heats the spa to set temperature only during filter cycles. "Ec"
will display solid when temperature is not current, and will alternate with tem-
perature when temperature is current.
Sleep Mode heats the spa to within 20°F of the set temperature only during fil-
ter cycles.The "SL" will display solid when temperature is not current and will
alternate with temperature when temperature is current.
Preset Filter Cycles
The first filter cycle begins 6 minutes after the spa is energized. The second filter
cycle begins 12 hours later.
Filter duration is programmable at the Master Control Pad for 2, 4, 6, 8 hours or
for continuous filtration. (Indicated by "FC"). The default filter time is 2 hours.
To program, press "Temp", then "Jets". Press "Temp" to adjust. Press "Jets" to
exit programming.
The low speed of the pump runs during filtration and the ozone generator
(if installed) will be enabled.
Freeze Protection
If the temperature sensors detect a drop below 40° F within the heater, then the
pump (as well as the heater, if necessary) will automatically activate to provide
freeze protection. The equipment stays on until the sensors detect that the spa
temperature has risen to within 15° F of the set temperature.