Owner`s manual

America’s Leader In Luxury
MASTER SPAS
35
MASTER SPA - LEGEND SERIES
Secondary Filter Cycle Programming (cont.)
Press "Mode/Prog" to see the "Program", "Filter 2", and "Start Time" icons.
Proceed as above.
Press "Mode/Prog" to see "Program", "Filter 2", and "End Time" icons.
Adjust the time as done above.
Pressing "Mode/Prog" will enter the new filter cycle times into the system
and display the current water temperature.
Pressing "Time" at any time during this programming sequence will save the
values entered up to that point and exit programming.
If you would like to select continuous filtration, set the filter 1 start and end
times to be the exact same time.
Setting the Time
Once the spa has been properly connected for the first time, notice the "Time"
icon appearing on the screen.
Press Then
Time Mode
Select the hour by pressing or
Warm Cool
(Each press changes the time by 1 hour)
Press to enter.
Mode
Select minutes by pressing or
Warm Cool
(Each press changes the time by 1 hour)
Press to exit the time setting procedure and enter the
Mode optional filter cycle programming.
Press to exit programming.
Time