Owner`s manual

America’s Leader In Luxury
MASTER SPAS
51
DOWN EAST AND FREEDOM - 1 AND 2 PUMP SYSTEMS
Initial Start-up
When your spa is first actuated,it will go into Priming mode,indicated by “Pr.”
The Priming mode will last for less than 5 minutes (press “Temp” to skip Priming
Mode) and then the spa will begin to heat the spa and maintain the water tem-
perature in the Standard mode.
Warm/Cool (80˚F - 104˚F / 26˚C - 40˚C)
The start-up temperature is set at 100˚F/37˚C.The last measured temperature is
constantly displayed on the LCD.
Note that the last measured spa temperature displayed is current only
when the pump has been running for at least 2 minutes.
To display the set temperature, press the “Temp” pad once.
To change the set temperature,press the pad a second time before the LCD stops
flashing. Each press of the “Temp” pad will continue to either raise or lower the
set temperature.
If the opposite direction is desired,release the pad and let the display revert to
the current water temperature.Press the pad to display the set temperature,
and again to make the temperature change in the desired direction.
After three seconds,the LCD will stop flashing and display the current spa
temperature.
Jets
Touch the “Jets”button once to turn pump 1 on or off,and to shift between low
and high speeds (if equipped).If left running,the low speed of the pump will
automatically turn off after 15 minutes.
Jets 2
Touch the second “Jets”button once to turn pump 2 on or off.If left running,
pump will automatically turn off after 15 minutes.
Light
Press the “Light” button to turn the light on and off.If left on,the light
automatically turns off after 4 hours.