Owner`s manual

America’s Leader In Luxury
MASTER SPAS
46
DOWN EAST (2 -3 PUMP SYSTEMS)
Jets 1
Touch the “Jets 1”button once to activate the low speed of the pump and again for
the high speed.Press the “Jets”button again to turn off the pump. If left running,
the low speed of the pump will automatically turn off after 4 hours, and the high
speed will automatically turn off after 15 minutes.The low speed of the pump
runs when pump 2 is on.It may also activate for at least 2 minutes every 30
minutes to detect the spa temperature and then to heat to the set temperature if
needed,depending upon mode.When the low speed turns on automatically, it
cannot be deactivated from the panel;however,the high speed may be started.
Jets 2 / Jets 3 (if equipped)
Touch the “Jets 2”or “Jets 3”button once to turn pump on or off. If left running,
pump will automatically turn off after 15 minutes.
Light
Press the “Light” button to turn the light on and off.If left on,the light
automatically turns off after 4 hours.
Mode
Mode is changed by pressing the “Warm”or “Cool” button,then pressing the
“Light” button.
Standard mode is programmed to maintain the desired temperature. Note that
the last measured spa temperature displayed is current only when the pump has
been running for at least 2 minutes.“Std”will be displayed momentarily when
you switch into Standard mode.
Economy mode heats the spa to the set temperature only during filter cycles.
"Ecn" will display solid when the temperature is not current,and will alternate
with the temperature when the temperature is current.
Sleep mode heats the spa to within 20˚F /10˚C) of the set temperature only
during filter cycles. "SLP" will display solid when the temperature is not current,
and will alternate with temperature when temperature is current.