Owner`s manual

America’s Leader In Luxury
MASTER SPAS
45
DOWN EAST (2 -3 PUMP SYSTEMS)
East Hampton / Portsmouth / Windsor / Exeter / Cape Cod
(2 Pump System)
East Hampton SE / Portsmouth SE / Windsor SE / Exeter SE/
Cape Cod SE
(3 Pump System)
Initial Start-up
When your spa is first actuated,it will go into Priming mode,indicated by “Pr.”
The Priming mode will last for less than 5 minutes (press “Warm”or “Cool”to
skip Priming Mode) and then the spa will begin to heat the spa and maintain the
water temperature in the Standard mode.
Warm/Cool (80˚F - 104˚F / 26˚C - 40˚C)
The start-up temperature is set at 100˚F/37˚C.The last measured temperature is
constantly displayed on the LCD.
Note that the last measured spa temperature displayed is current
only when the pump has been running for at least 2 minutes.
To display the set temperature, press the “Warm” or “Cool” pad once.
To change the set temperature,press the pad a second time before the LCD stops
flashing. Each press of the “Warm” or “Cool” pad will continue to either raise or
lower the set temperature.
After three seconds,the LCD will stop flashing and display the current spa
temperature.