Owner`s manual

America’s Leader In Luxury
MASTER SPAS
39
MASTER SPA
Diagnostic Messages (cont.)
Periodic Reminder Messages
(Press the “Mode” button to reset a displayed reminder)
Message
Message
Meaning
When your spa is first actuated,
it will go into Priming mode.
Temperature unknown.
Temperature not current in Economy or
Sleep mode.
Standby Mode has been activated by
pressing a button combination on the
user panel.
Meaning
Every 7 days
Every 7 days
Every 30 days
Every 30 days
Every 90 days
Every 180 days
Every 180 days
Every 365 days
Action Required
See the M-7 Installation Instruction Manual for
complete instructions on Power-up and Pump Priming.
The Priming mode will last for up to 4 minutes and
then the spa will begin to heat and maintain the water
temperature in the Standard mode.
After the pump has been running for 2 minutes,
the temperature will be displayed.
In Economy or Sleep mode,the pump may be off for
hours outside a filter. If you wish to see the current spa
temperature, either switch to Standard mode or turn
Jets 1 on for at least two minutes.
Press any button to leave Standby mode and return to
normal operation.
Action Required
Test and adjust ph chemical levels per manufacturer’s
instructions.
Test and adjust sanitizer chemical levels per
manufacturer’s instructions.
Remove, clean,and reinstall filter per
manufacturer’s instructions.
Test and reset GFCI per manufacturer’s instructions.
Drain and refill spa per manufacturer’s instructions.
Clean and condition cover per manufacturer’s instructions.
Clean and condition wood per manufacturer’s instructions.
Install new filter.
Do not attempt service of this control system. Contact your dealer or service organization for assistance.
Follow all owner’s manual power connection instructions. Installation must be performed by a licensed
electrician and all grounding connections must be properly installed.
WARNING! SHOCK HAZARD! NO USER SERVICEABLE PARTS.