Owner`s manual

America’s Leader In Luxury
MASTER SPAS
36
MASTER SPA - LEGEND SERIES
Light
Some systems are equipped with both a spa light and a fiber optic light;however,only one
can be assessed by this panel.Depending upon how your spa is equipped and configured,the
“Light”button will operate in one of two ways:
1.) Press the "Light" button to turn the spa light on and off.
2.) If a fiber-optic light with wheel is installed,press the “Light” button once to
start the light and wheel, press it again to stop the wheel,and then again to
turn the light off.The fiber optic icons stands still when the fiber optic light
is on by itself,and rotates when the color wheel is also on.
If any light is left on,it will automatically turn off after 4 hours.
Circ Pump
Your system may be configured to work in one of three different ways:
1.) The circ pump operates continuously (24 hours) with the exception of
turning off for 30 minutes at a time when the water temperature reaches
3˚ F (1.5˚C) above the set temperature (most likely to happen in very
hot climates).
2.) The circ pump stays on continuously, regardless of water temperature.
3.) The circ pump will come on when the system is checking temperature
(polling),during filter cycles, during freeze conditions,or when another
pump is on.
Preset Filter Cycles
On your MS8000 system,the circ pump,low speed of pump 1,and the ozone
generator will run during filtration.At the start of each filter cycle,the lowest
speed of all pumps will run for 5 minutes.
(The following is specific to all systems that are programmed according to time)
There are two filter cycles per day.The start/end times of each cycle are
programmable.To program, set time as instructed above, then press
“Program/Mode” to advance to the next setting (or to exit after the last setting).
The default filter cycles are as follows:
The first filter cycle is automatically activated at 8:00 AM and operates the pump
until 10:00 AM.The filter 1 indicator icon will light when filter 1 is running.
The second filter cycle is automatically activated at 8:00 PM and operates the
pump until 10:00 PM.The filter 2 indicator icon will light when filter 2 is
running.