Owner`s manual

America’s Leader In Luxury
MASTER SPAS
34
MASTER SPA - LEGEND SERIES
Optional Filter Cycle Programming (cont.)
Press “Program/Mode” to see the “PROGRAM,”“FILTER 2”and “END TIME”
icons.Adjust the time as done above.
Pressing “Program/Mode” will enter the new filter cycle times into the system
and display the current water temperature.
Pressing “Time”at any time during this programming sequence will save the values entered
up to that point and exit programming.
If you would like to select continuous filtration,set the filter 1 start and end
times to be the exact same time.
Temp Set (80˚F - 104˚F / 26.0˚C - 40.0˚C)
The start-up temperature is set at 100˚F/37.5˚C. The last measured temperature
is constantly displayed on the LCD.
Note that the last measured spa temperature displayed is current only
when the pump has been running for at least 2 minutes.
Warm / Cool
Press the "Warm" or "Cool" button once to display the set temperature. Each
time either button is pressed again,the set temperature will increase or decrease
depending on which button is pressed. After three seconds,the LCD will
automatically display the last measured spa temperature.
Time
When time hasn’t been programmed, the TIME icon flashes. To set the time,
press "Time" then "Program/Mode". Use the "Warm" and "Cool" buttons to
adjust time.See previous page for more detailed instructions.
Program/Mode
This button is used to switch between standard,economy, and sleep modes.
Press "Program/Mode" to enter mode programming,press "Cool" to cycle
through to desired mode (LCD flashes until confirmed), then press
"Program/Mode" to confirm selection.
Standard mode maintains the desired temperature. Note that the last measured
spa temperature displayed is current only when the pump has been running for at
least 2 minutes. The "STANDARD" icon will display until the mode is changed.
Economy mode heats the spa to the set temperature only during filter cycles.
The "ECONOMY" icon will display until mode is changed.
Cont.page 35