Owner`s manual

America’s Leader In Luxury
MASTER SPAS
32
MASTER SPA - LEGEND SERIES
Initial Start-up
When your spa is first actuated,it will go into Priming mode (after displaying
some configuration information). The Priming mode will last for up to 4 minutes
and then the spa will begin to heat and maintain the water temperature in the
Standard mode. You can exit Priming mode early by pressing "Warm" or "cool".
Icon Legend
Heat Icon – Indicates different stages of heating.
Jets Icon – Spins fast on high speed;spins slow on low speed.
Fiber Optic Light Icon – Spins when the wheel is on;
stands still when wheel is off.
Your Master Spas MS8000 is an EL8000 system.Please reference the sections in this document that apply to the EL8000.
Note regarding the EL and GL systems: Mach 2.0 EL and GL systems function identically,but conform to different International requirements.
This reference card will refer to EL systems for the sake of simplicity,but the information given applies to both EL and GL products.
This reference card lists all features that are available.Your spa may not respond as described in this document as specific operation
varies by system and equipment used.If your spa is not fully equipped,the panel buttons on your spa control may not be laid out
as shown.
The pump responsible for heating and filtration (circ systems) will be referred to simply as the pump.
Timeouts refer to a preset length of time that a function is programmed to operate before shutting off automatically. Certain
conditions (filters or freeze) can cause a function to operate longer, while faults can cause a function to operate for a shorter
length of time.The system keeps track of timeouts regardless of other conditions occurring.
In multi-button sequences,if buttons are pressed too quickly in sequence,they may not register.