Owner`s manual

America’s Leader In Luxury
MASTER SPAS
23
WATER QUALITY MAINTENANCE SCHEDULE-ECO PUR
™
Legend Series Spas and Down East Spas
BEFORE EACH USE - Check spa water with a test strip for proper sanitation
levels and adjust accordingly to the proper levels.
ONCE A WEEK - Add 3 Tablespoons of a non-chlorine shock or 1 tea
spoon of Dichlor to spa per 250 gallons.
3 TIMES A WEEK - Test water using chemical test strips.Adjust sanitizer,
pH and Alkalinity accordingly.
ONCE A MONTH* - Soak your filter elements overnight in a bucket with spa
Filter Cleaner and then rinse with clean water before
re-inserting. (The ECO PUR
™
mineral element should
never be cleaned in a filter cleaner.Just rinse
with water.)
EVERY 180 DAYS - Drain and refill your spa, replace with a new
ECO PUR
™
element,repeat start up procedure.
AFTER EACH USE - Add 1 tablespoon of non-chlorine shock or 1/3
teaspoon of Dichlor to spa per 250 gallons.
AS NEEDED - If water looks hazy, shock treat with 1 teaspoon of
Dichlor per 500 gallons.
* These are general recommendations for water quality maintenance that may
vary by usage and or bather load.Depending on bather load and frequency of
use,drain and refill times may vary as well as the frequency of cleaning your
filters.
*Foam Gone may be used when excessive foaming occurs.Be sure to use only
a drop or two at a time.Over use of Foam Gone will result in cloudy,
milky water.
NOTE:
As an alternative to non chlorine shock, Dichlor may be substituted.
1 tsp. Dichlor = 3 tablespoons of non chlorine shock
USE ONLY SPA CHEMICALS
(some pool chemicals are not suitable for spa use).
* when cleaning filters, be sure to never have the pumps (including the
circulation pump) running without the filters in place.Failure to do so may
result in debris in the pumps causing unwarranted damage.