Owner`s manual

10
GLOSSARY OF SPA TERMINOLOGY
13. FILTER LID -Your filter lid will serve to prevent major objects from
entering your filter area and possibly damaging your filter elements which are
located under the filter lid.These filter elements are designed to remove
small debris and oils from your spa water.
14. WEIR GATE -The weir gate is the horizontal door located in front of the
filters that trap debris in the filter area.
15. SPA LIGHT -Your spa light is designed for safety and is located in the
interior wall of your spa.The on/off switch is located on the topside
control panel.
16. EQUIPMENT CONTROL SYSTEM - This houses the wiring and electrical
components necessary to operate the spa.
17. SPA HEATER - This element is an electric heater housed in a stainless steel
tube.It is thermostatically controlled and equipped with a high-limit
temperature safety shut-off sensor.The high-limit sensor cannot be reset until
the temperature within the heater assembly drops several degrees below the
shut-off temperature of 108° - 110° F (varies by model).Should the
high-limit switch trip repeatedly, contact your dealer or qualified service
representative to diagnose the problem.
18. SLICE VALVES - These valves are used by service personnel to shut off water
to the heater,main pump system and secondary pump system so that the
water does not need to be drained should the spa require service.
*NOTE: Slice valves must be completely open during normal operations.
Slice Valve
and Pump Union