Specifications

1
IMPORTANT SAFETY INSTRUCTIONS
When installing your spa and using this equipment, basic safety precautions should always be followed. For your
safety and the safety of others it is vital that the following be observed:
• READ AND FOLLOW ALL INSTRUCTIONS! The following instructions are required by UL 1563 standard to
be printed as a condition of their listing this product. They contain important safety information we strongly
urge you to read and apply.
• DANGER - TO REDUCE THE RISK OF INJURY: Do not permit children to use spa unless they are closely
supervised at all times.
WARINING SIGN MUST BE POSTED
The WARNING sign (RED) above is packed with your new Platinum Spa. This sign must be posted in a prominent place
in close proximity to the spa installation site immediately upon completion of spa installation.
• WARNING SIGN - It is extremely important that this sign be permanently placed in clear view of any persons
using the spa. Occasional spa users may not be aware of some of the dangers hot water poses to pregnant
women, small children, and people under the influence of alcohol. If you did not receive a warning sign or your
sign has become damaged, please contact the manufacturer.
• DANGER - A wire connector is provided on this unit to connect a minimum No. 6 AWG (10 mm2) solid copper
conductor between unit and any metal equipment, metal enclosures of electrical equipment, metal water pipe, or
conduit, if that item is located within 5 feet (1.5m) of the unit.
• DANGER - RISK OF ACCIDENTAL DROWNING: Extreme caution must be exercised at all times, to prevent
unauthorized access by children. To avoid accidents, ensure that children cannot use spa unless they are
supervised at all times. Cover spa and use safety locks to prevent accidents.
• DANGER - TO REDUCE THE RISK OF INJURY: The suction fittings in the spa are sized to match the specific
water flow created by the pump/pumps. Should the need arise to replace the suction fittings or the
pump/pumps, be sure that the flow rates are compatible.
• DANGER - RISK OF ELECTRICAL SHOCK: Install at least 5 feet (1.5m) from all metal surfaces. As an
alternative, a spa may be installed within 5 feet (1.5m) of metal surfaces if each metal surface is permanently
connected by a minimum No. 6 AWG solid copper conductor to the wire connector on the terminal box that is
proved for this purpose. Do not permit any electrical appliance, such as a light, telephone, radio or television
within 5 feet (1.5m) of the spa, unless factory installed.
• Position spa to provide proper drainage and accessibility of electrical compartments.
• For floor recessed spas, install to permit access for servicing from above or below floor.
• NEVER USE AN EXTENSION CORD!
• Consideration should be taken for water splash out. Water can ruin wood floors and some finishes.
• DO NOT use a wall switch, ground fault circuit interrupter, circuit breaker, fuse, or plugging and unplugging the
spa as a means of turning on or off your spa for normal everyday use.
• DO NOT block access door.
• Set the spa on a firm level (flat) surface. DO NOT set spa on blocks as structural damage may occur to spa.
• WARNING - To reduce the risk of injury the water in a spa should never exceed 40.0° C (104.0° F). Water
temperatures between 38.0° C (100.0° F) and 40.0° C (104.0° F) are considered safe for a healthy adult. Lower
water temperatures are recommended for young children and when spa use exceeds 10 minutes.