Specifications

OPERATING INSTRUCTIONS

Warm/Cool

Press the “Warm” or “Cool” buttons once to display the set temperature. Each time either button is pressed again, the set

temperature will increase or decrease depending on which button is pressed. After three seconds, the LCD display will

automatically display the current temperature the spa water.

Mode/Program

Mode

Mode is changed by pressing the “Warm” or “Cool” button, then pressing the “Mode” button.

• Standard Mode is programmed to maintain the desired temperature. Note that the last measured spa temperature

displayed is current only when the circ pump has been running for at least 2 minutes. “Std ” will be displayed

momentarily when you switch into Standard Mode.

• Economy Mode heats the spa to the set temperature only during filter cycles. “Ecn” will display solid when

temperature is not current, and will alternate with temperature when temperature is current.

• Sleep Mode heats the spa to within 20°F/10°C of the set temperature only during filter cycles. “SLP ” will display

solid when temperature is not current, and will alternate when temperature is current.

Standby Mode

Pressing “Warm” or “Cool” then “Jets2” button will turn off all spa functions temporarily. This is helpful when changing filter

cartridges. Press any button to exit Standby mode.

Jets 1

Press the “Jets 1” button to turn pump 1 on or off, and to shift between low and high speeds. If left running, the low speed

turns off after two hours and high speed turns off after 15 minutes.

Jets 2

Press the “Jets 2” button to turn pump 2 on or off. If left running, the pump 2 turns off after 15 minutes.

Blower

Press the “Blower” button to turn blower on or off. If left running, the blower turns off after 15 minutes.

LED Light

Press the “Light” button to turn the spa light system on and off. LED light system preprogrammed with assortment of lighting

effects. When you turn Light off and turn on again within five (5) seconds it advances to the next effect. When you turn Light

off for more than five (5) seconds, it remembers that last effect you selected. The next time you turn on the Light will display

the same effect. The Light will automatically turn off after approximately four (4) hours.

The spa is equipped with LED light system and music module the following sequence effects can be selected via on-off Light

button:

1) Color wheel; 2) Music modulated mode; 3-8) Different colors; 9) Flashing through the color sequence.