Specifications

10
START-UP INSTRUCTIONS
FOR BEST RESULTS, READ EACH STEP IN ITS ENTIRETY BEFORE PROCEEDING WITH STEP.
FILLING THE SPA
Clear all debris from inside the spa. At the factory your spa shell was cleaned and polished, but you may want to
treat it with a specially formulated spa cleaner available by phone at 1-866-486-1365. Make sure the spa has
been installed correctly, including electrical wiring connections as specified in the wiring diagram, and the spa is
level.
Do Not Over Fill. Never fill your spa with water from a water softener, or use hot water while filling. Ensure that
your spa drain is shut off. Remove your filter lid. Place your garden hose into the filter housing and begin filling
with clean water. Continue filling spa until the water level is 2 inches above the highest water jet. Remember
every person entering a spa displaces a given volume of water, so adjust water level to number of people who
will be entering spa. If your water is extremely “hard”, it is preferable to fill halfway with hard water and the rest of
the way with softened water. Or, you may fill the entire spa with hard water if you use a special water additive
available by phone at 1-866-486-1365.
S
p
eaker
Pillow
Control Panel
Waterfall
Waterfall
Control
Pillow
Air Control
Filter Lid
Aromathera
py
S
p
eaker
Pillow
Diverter Valve
Pillow
Air Control
Air Control
Figure 6
Figure 7
Weir Door Filter
Dual Filter Cartridge
Pillow
Air Control
Air In
j
ectors
Drain
Air Control
Audio Remote
Control