Owner`s manual

Diagnostic Display Messages on Main Control Panel

SMART WINTER MODE / FLASHING ▲ ABOVE FILTER ICON

This system prevents the water from freezing in the plumbing or the pumps. An onboard

sensor continuously checks the ambient air temperature in the control pack. If at any time

the temperature falls from a range of 43ºF the Smart Winter Mode will be activated for the

next 24 hours, even if the temperature returns to above 43ºF. During this Smart Winter

Mode the range of temperature will determine the frequency of the pumps operation. The

colder the ambient temperature, the more frequently the pumps will run. The time range will

vary from every 15 minutes to every 2 hours. When the pumps are operating because of this

feature, the filter cycle icon on the display will flash. No corrective action is necessary.

SUMMER SETTING MODE / ”SSET”

Your spa is equipped with this feature to prevent heat build up.

Standard (Outdoor) Mode: When water temperature is 2ºF greater than set temperature, the

circulation pump and ozone generator will turn off for 3 hours. After 3 hours the circulation

pump and ozone generator will turn on again for 1 hour and pump 1 will run for 1 hour then

turn off again for 3 hours; this cycle will keep repeating. When the circulation pump and

ozone generator are off “SSEt” and the water temperature are alternately displayed on the

panel (SSEt = summer setting). The circulation pump turns on automatically if the water

temperature drops below 1ºF of the set temperature.

Operations Trouble Shooting Guide Cont...

Problem Probable Cause Solutions

Spa jets/pump(s) • Normal power filtration cycle • No action necessary

turn on • Summer Setting mode cycle activated • No action necessary

automatically • Smart Winter mode cycle activated • No action necessary

Not able to • Panel may be locked • Hold down blower key until

operate main “Uloc” appears on the digital display

control panel • Panel may have malfunctioned • Contact your dealer

Water does • Bad water chemistry • Balance water

not clear up • Dirty filter cartridges • Clean or replace filters

• Ozone generator not operating or • Locate ozone generator, look for

ozone chip needs replacement ultraviolet light to be illuminated

through window on ozone generator

• Bromine/chlorine residual levels • Adjust Bromine/chlorine levels.

too low Shock if necessary. May have to

replace water