Owner`s manual

____________________________________________________________________________________________
__________________________________________________________________________________________
14
STEREO MODELS AVAILABLE ON THE
STEREO MODELS AVAILABLE ON THE STEREO MODELS AVAILABLE ON THE
STEREO MODELS AVAILABLE ON THE EAST HAMPTON
EAST HAMPTONEAST HAMPTON
EAST HAMPTON
/
//
/P
PP
POR
OROR
ORTSMOUTH/WINDSOR
TSMOUTH/WINDSORTSMOUTH/WINDSOR
TSMOUTH/WINDSOR/E
/E/E
/EXETER/CAPE COD
XETER/CAPE CODXETER/CAPE COD
XETER/CAPE COD(2 pump Systems)
(2 pump Systems) (2 pump Systems)
(2 pump Systems) and
and and
and
SE MODELS
SE MODELSSE MODELS
SE MODELS
Refer to the Sony’s Stereo Operations Manual enclosed in your Owner’s Manual Packet.
MODE
MODEMODE
MODE
Mode is changed by pressing the “Temp” button, then pressing the “Light “button.
Standards Mode is programmed to maintain the desired temperature. Note that the last
measured spa temperature displayed is current only when the pump has been running for
at least 2 minutes. “St” will be displayed momentarily when you switch into Standard
Mode.
Economy Mode heats the spa to the set temperature only during filter cycles. “Ec” will
display solid when temperature is not current, and will alternate with temperature when
temperature is current.
Sleep Mode heats the spa to within 20° F of the set temperature only during filter cycles.
“SL” will display solid when temperature is not current, and will alternate with
temperature when temperature is current.
EAST
EASTEAST
EAST HAMPTON/
HAMPTON/HAMPTON/
HAMPTON/PORTSMOUTH
PORTSMOUTHPORTSMOUTH
PORTSMOUTH/WINDSOR
/WINDSOR/WINDSOR
/WINDSOR/
//
/
EXETER/CAPE
EXETER/CAPEEXETER/CAPE
EXETER/CAPE CO
COCO
COD
DD
D
(2
(2(2
(2 PUMP
PUMP PUMP
PUMP S
SS
SYSTEMS
YSTEMSYSTEMS
YSTEMS)
))
)
Your spa side control panel consists of two main parts. The control pads operate
individual functions and allow for several programming modes. The LCD Display shows
constant water temperature and will monitor various functions. When your spa is first
activated, it will go into priming mode indicated by “Pr” on the display lasting 6 minutes.
Your spa will maintain the water temperature at the programmed setting. It has been
factory set at 100° F. Temperature adjustment is controlled by pushing the “Temp”
button. The display shows the actual water temperature unless the pad is pressed. When