Owner`s manual

____________________________________________________________________________________________
__________________________________________________________________________________________
12
EXETER
EXETEREXETER
EXETER SE
SESE
SE/CAPE
/CAPE/CAPE
/CAPE COD
CODCOD
COD SE
SESE
SE MODELS
MODELSMODELS
MODELS
PORTSMOUTH
PORTSMOUTHPORTSMOUTH
PORTSMOUTH SE/WINDSOR
SE/WINDSORSE/WINDSOR
SE/WINDSOR SE
SESE
SE
(3
(3(3
(3 PUMP
PUMP PUMP
PUMP S
SS
SYSTEM
YSTEMYSTEM
YSTEM/SE
/SE/SE
/SE)
))
)
Your spa side control panel consists of two main parts. The control pads operate
individual functions and allow for several programming modes. The LCD Display shows
constant water temperature and will monitor various functions. When your spa is first
activated, it will go into priming mode indicated by “Pr” on the display lasting 6 minutes.
Your spa will maintain the water temperature at the programmed setting. It has been
factory set at 100° F. Temperature adjustment is controlled by pushing the “Temp”
button. The display shows the actual water temperature unless the pad is pressed. When
the pad is pressed, the display will show the set temperature. Pressing the pad a second
time will cause the set temperature to increase or decrease depending on what direction
was last chosen. Each successive press will change the set temperature in the same
direction. Set temp display will flash while you are setting temp. Display will show
constant when set temp is accepted.
If the opposite direction is desired, release the pad and let the display revert to the actual
water temperature again. Press the pad to display the set temperature, and again to make
the temperature change in the desired direction. After three seconds, the LCD will
automatically display the current spa temperature.
JET
JETJET
JET /
//
/ PUMP
PUMPPUMP
PUMP OPERATION
OPERATIONOPERATION
OPERATION
The Exeter SE and Cape Cod SE models are equipped with a three pump system, one
pump operates on either high or low speed. Pressing the first “Jets” button to the right of
the display once will turn the pump on low speed. Press again for high speed and once
more for off. Pressing the second “Jets” button will turn pump two on high speed, press
button again and pump turns off. Pump two and three are activated only in high speed.
Pressing the third jet button will turn pump three on high speed, press the button again
and the pump turns off.