SDS

SAFETY DATA SHEET
SDS MASTERFLEX REFLECTIVE Page 10 of 10
Section 16. Other information
Hazardous Material Information System (USA) (HMIS ® ratings)
Health: 1
Flammability: 0
Physical hazards: 0
Caution: HMIS ® ratings are based on 0-4 rating scale, with o representing minimal hazards or risks, and 4 representing
significant hazards or risks. Although HMIS ® ratings are not required on SDSs under 29CFR 1910. 1200, the preparer may
choose to provide them. HMIS ® are to be used with a fully implemented JHMIS ® program. HMIS ® is a registered mark of
the National Paint & Coatings Association (NPCA). HMIS ® materials may be purchased exclusively from J.J. Keller (800) 327
– 6868.
Key to abbreviations: SDS: Safety Data Sheet
ATE = Acute Toxicity
BCF = Bioconcentration factor
GHS = Globally Harmonized System of classification and Labelling of chemicals.
IATA = International Air Transport Association
IMDG:
IBC = International Maritime Dangerous Goods
LogPow = logarithm of the octanol/water partition coefficient
MARPOL = International Convention for the prevention of pollution From Ships,
1973 as modified by the Protocol of 1978. (“Marpol” = marine pollution)
UN = United Nations
Disclaimer:
Master Paints & Chemical Corporation, cannot anticipate all conditions under which this information and its product, or
the products of other manufacturers combination with its product, may be used. It is the user’s responsibility to ensure
safe conditions for handling, storage and disposal of the product, and to assume liability for loss, injury, damage or expense
due to improper use. The information in the sheet was written based on the best knowledge and experience currently
available.
Reviewer Revision
Date of issue / date of revision: 03/29/2019 Date of previous revision: 04/04/2018 Revision number: 5