Product Manual

7
Determine MPH
Determining the proper walking speed can be done by marking off a length of 100 feet. The speed
chartindicates the number of seconds it takes to travel 100 feet.
Caution
Do not spray on windy days. Protective clothing must be worn in some cases. Be sure to read the
chemical label carefully.After all calibrations have been completed, add water and chemical to the
tank. Always follow chemical manufacturer’s instructions for mixing.
READ and UNDERSTAND the Owner's Manual completely before using this sprayer.
Assemble, test, and use only in accordance with the Owner's Manual instructions.
READ and FOLLOW chemical label instructions. Pesticides are hazardous chemicals.
KNOW emergency procedures BEFORE handling chemicals. Sprayer leaks, bodily chemical
contact, poisoning, and spills require immediate response.
AVOID inhaling, ingesting, or coming into contact with any chemicals.
WEAR personal protective gear when filling, using, cleaning, and servicing the sprayer.
KEEP sprayer and spray materials away from children and pets. Pesticides are especially toxic to
them.
EXERCISE CAUTION in vehicle handling when towing/hauling a filled sprayer to avoid loss of
control or sprayer overturning.
DO NOT TURN ON POWER to sprayer until ready to spray in order to avoid unintentional spray
release.
Improper use of the sprayer or handling of chemicals could result in serious injury or illness to
the operator or nearby persons/animals, or could cause damage to the environment.
Operation
Ensure battery is fully charged to provide optimum efficiency from the 12volt pump.
Never allow the battery to discharge completely. Doing so will damaged the battery and void
warranty. Always turn off the power switch after use to ensure the battery will not be drained
during storage. This can be easily confirmed by the indicator light in the power switch. If the switch
is on it will illuminate.
- Sprayer Inspection
o Turn the valve located in the back panel to the off position. This will ensure the nozzle does not
begin to spray when the pump is activated. The pump can be operated with the power switch
located on the upper handle. Remove the tank lid and then fill the spray tank with clean water
through the basket strainer and replace the tank lid. At this point it’s a good time to inspect the
sprayer for any leaks. Any harsh chemical that was left in the sprayer may have had an adverse
effect on the sprayer.
o Activate the pump by turning on the power switch. The pump, when activated, will begin to run
until 40 psi is reached. The built-in pressure switch will then shut off the pump. Inspect for any
leaks.
Speed MPH Time required to travel 100 ft
1 68 Sec.
2 34 Sec.
3 23 Sec.
4 17 Sec.