Product Manual

4
Wiring Assembly
Secure the Wire Clamps on the Handle
and Lower Frame using the Phillips
Screwdriver.
Locate the Switch on the Upper Handle
and make sure it is in the OFF position as
shown.
Locate the Wiring Harness Connector at
the base of the Handle. Locate the
Connector under the Back Panel, and
connect it to the Wiring Harness
Connector, making sure it is fully seated.
Verify Pump and Switch operation by
turning the Switch to the ON position. If
power is connected properly, the Switch
will light up and you will hear the Pump
run. Turn the Switch back OFF.