Instruction manual

7ML19981FB06 MultiRanger 100/200 – INSTRUCTION MANUAL Page 27
mmmmm
Operation
PROGRAM Mode
The MultiRanger is programmed by setting its parameters to match your specific
application. Most parameters are indexed, allowing you to set the parameter to specific
conditions and to more than one input or output. When the MultiRanger is in PROGRAM
mode, you can change these parameter values and set operating conditions.
Please refer to the
Parameter Reference
section on page 117 for a full listing and
explanations of parameter values.
The MultiRanger’s primary programming is by the hand programmer. Other access is
available through Dolphin Plus software (purchased separately).
Starting PROGRAM Mode
Hand Programmer
The hand programmer gives you direct access to
the MultiRanger.
Aim the hand programmer and press PROGRAM
key.
For your convenience, the
programmer has a magnetic mounting
strip on the back. Keep programmer
nearby for easy access.
Point the programmer at the IR port
above the display and press the keys.
Unless otherwise noted, each valid
key press should produce a change in
the LCD. Verify when programming the
unit.
Notes
To activate PROGRAM from RUN mode, press PROGRAM
and then
DISPLAY
The display briefly reads ---- while the measurement reading is verified.
Reading level and other data is displayed and programmed relays are
operated.
Placing a programmed unit that is in normal operation into PROGRAM mode
de-energizes all control relay outputs. Be sure to bypass the MultiRanger while
programming it.
Notes:
The battery in the programmer is not
replacable.
The hand programmer is ordered
separately from Siemens Milltronics
Infrared
Port