Instruction manual

7ML19981FB06 MultiRanger 100/200 – INSTRUCTION MANUAL Page 245
Appendix E: Updating Software
Appendix E: Updating Software
Updating Software
To update the software in the MultiRanger, please contact your Siemens Milltronics
representative to obtain the software. For a complete list of representatives, go to
www.siemens.com/processautomation
.
To install the software, please complete the following:
1. Connect your PC or laptop to the MultiRanger RJ-11 RS-232 port.
2. Run the .exe Downloader program in the software. Use this to set the RS-232
settings to match your MultiRanger. Please note that the software default settings
will already match the default settings of the unit. Changes are only necessary if the
RS-232 settings in the unit have been changed.
3. Complete the Downloader program steps.
4. Verify that Downloader confirms a succesful upgrade before exiting.
5. Complete a Master Reset (P999) after a successful upgrade, before re-entering
parameters.
WARNINGS:
1. All parameter values will be lost during software upgrade.
Record your current parameters manually or using Dolphin Plus or
SIMATIC PDM before upgrade.
2. Disable all pumps and alarms before updating software, as
relays can change state during the software update causing pumps
to turn on or off .