Installation Guide

Deadbolt Rekeying Grade 3 Residential
Insert key.
Note: The rekeying procedure is the same
for brass cylinder housings or die cast
housings.
Disassemble the deadbolt, remove trim
collar from the cylinder.
Rotate the cap tool counterclockwise to
loosen the cap.
Remove cap and tailpiece.
Remove cap pin and cap pin spring
Rekey using a follower as instructed under
Leverset Rekeying.
Check reassembled cylinder to ensure
functionality but do not remove the key.
Insert the cap pin spring and the cap pin. Put cap and tailpiece in position.
Tighten cap with cap tool and check key
for ease in turning. If tight, loosen cap one
retention point and check.
42
Tail
Piece
Locking
Nut
Plug
Spring
Cylinder Housing
Retaining
Pin