Installation Guide

Unlike a safe, this combination is applied three times clockwise to 12, two times counterclockwise to 40 and one time
clockwise to 14. At that point, you should feel the fence enter the gate and then may turn the dial in the direction required to
throw or retract the bolt.
Encoding a lock to a new combination follows the same disassembly and reassembly steps but uses different calculations to
determine fly locations on the various disks. As you can see here, the worksheet for encoding is different also.
Use the following steps to reassemble the lock.
Ensure that drive disk 1 has not
been moved from the decoded
position and place it over the
cylinder
Install a spacer washer, disk 2
and another spacer washer
Install disk 3 and another
spacer washer
Install fence ring and wave
washer
Install dial ring, making sure
wave washer is centered and
disrupter spring is correctly
positioned
Set handing by moving cam
slot to bolt edge side and make
tailpiece horizontal Reinstall cam
Attach baffle plate and
mount lock on door. Try the
combination to lock and unlock
to verify the decoding
ENCODING
Disk Set to Formula Combination
The disk that contacts the dial
1
Align with Dial Index
3
The middle disk
2
Second number minus 1.
Then subtract third number
if less than zero, add 50 until
between 0 and 49.
2
The disk that comes out first
3
Add set positions for disks
1 and 2 plus 6. Subtract
that from combination 1. If
less than zero, add 50 until
between zero and 49.
1
13