Installation Guide

Deadbolt Information Grade 2 Residential
9
To change latch faces:
1. Use a flat screwdriver to separate the face plate.
2. Snap selected latch face onto back plate.
For drive-in installation:
1. Put the round face plate into
latchbolt as illustrated.
2. Press the cover plate to
lock in with latch and round
face plate.
3. Push the floating sleeve
forward until it is positioned
at the latch.
Attach the latch face that matches the mortise in the edge of your door
Attach the latch face that matches the mortise in the edge of your door
To change latch faces:
1. Use a flat screwdriver to separate the face plate.
2. Snap selected latch face onto back plate.
For drive-in installation:
1. Put the round face plate into latchbolt as
illustrated.
2. Press the cover plate to
lock in with latch and
round face plate.
3. Push the floating sleeve forward until it
is positioned at the latch.
Back Plate
Cover Plate
Floating Sleeve
Round Face Plate
Drive-In Latch
Floating Sleeve
Face Plate
Attach the latch face that matches the mortise in the edge of your door
To change latch faces:
1. Use a flat screwdriver to separate the face plate.
2. Snap selected latch face onto back plate.
For drive-in installation:
1. Put the round face plate into latchbolt as
illustrated.
2. Press the cover plate to
lock in with latch and
round face plate.
3. Push the floating sleeve forward until it
is positioned at the latch.
Back Plate
Cover
Plate
Floating Sleeve
Round Face Plate
Drive-In Latch
Floating Sleeve
Face Plate
The bolt has changeable face plates to allow square corners, radiused corners or a drive-in face plate.
The deadbolt is available with a single or double cylinder function and may use any of the Master Lock Door Lock type
BumpStop
®
cylinders, a Kaba Lori 1599 cylinder or any other ‘size compatible’ cylinder. The bolt has an adjustable backset
for 2 3/8" or 2 3/4".
To change backset:
Changing your backset is as
simple as gripping and turning
the back portion of the latch.
Turn clockwise to extend to
2-3/4" or counter-clockwise to
return to 2-3/8". As the back
rotates, it will 'spiral' in or out,
as the mechanism follows the
machined groove.
When extending to 2-3/4", be sure to
flip the entire latch assembly before
placing it in the door. The tailpiece
receiver hole (
2-3/8"
60mm
2-3/4"
70mm
)should always
be postioned at the bottom of the
assembly.
Adjust the latch to match the backset dimension on your door
Combination NightWatch
®
Grade 2 Residential
2-3/8"
60mm
2-3/4"
70mm
2-3/8"
60mm
2-3/4"
70mm