Specifications
30
SYSTEM TROUBLE ERROR CODES
E07-00
'Download Failure'
'E07-00 SERVICE'
Download attempt failure.
E08-NN
SYStrbl E08 xxx
MM/DD/YY HH:MM
'Telco Line Fail '
'E08-NNN SERVICE '
Telephone line failure (system trouble displays after a programmed delay of low on hook voltage and no off hook line current
from connected phone line). NN = Telco line number 1 or 2.
E09-00
SYStrbl E09 xxx
MM/DD/YY HH:MM
' COLD START '
'E09-000 SERVICE '
A system cold start was performed, erasing all programmed data in the control panel such as the Dealer Program, Zone
Description Data and Schedules.
E14-NNN
SYStrbl E14 xxx
MM/DD/YY HH:MM
'NacRly BoardTrbl'
'E14-000 SERVICE '
NAC or Relay board response failure. NNN = Relay board number (address). Check to make sure correct Relay group
address jumpers are set (no duplicates) and GEMC-RM3008’s and GEMC-OUT8’s are wired to the correct bus (either the Fire
bus or the Burg bus). If the GEMC-FW-SLC or GEMC-BSLC is used, check to ensure correct relay group dip switch settings.
If the GEMC-NAC7S or GEMC-NAC7L is used, check to ensure the address jumpers are set correctly.
E15-NNNNNN
SYStrbl E15 xxx
MM/DD/YY HH:MM
'RFpnt Tamper'
'E15-NNN XXXXXX'
Wireless RF Transmitter or SLC Point cover removed or the unit is removed from its mounting location and/or an SLC
device cover is removed. "XXXXXX" is the wireless device 6-digit ID map number or SLC point address. NNN is the associ-
ated zone number
E16-NN
SYStrbl E16 xxx
MM/DD/YY HH:MM
'RFRec JammedTrbl'
'E16-000 SERVICE '
Wireless RF Receiver or Burg SLC Trouble. NN = Receiver/SLC Module address (1-4). Either a Receiver is receiving a
constant conflicting signal or noise that may interfere with receiving signals, or a GEMC-BSLC module has detected a short on
the bus (class A or B) and/or an open on a class A loop. Consider moving Receiver location or repairing SLC loop.
E17-NN
SYStrbl E17 xxx
MM/DD/YY HH:MM
'RFRec Tamper'
'E17-000 SERVICE '
Wireless RF receiver cover removed or removed from mounting location.
NN = Receiver address (1-4).
TBL #
FIRE KEYPAD DISPLAY
KEYPAD TROUBLE DESCRIPTION