TABLE OF CONTENTS Package Contents ............................................................................................................... 3 Hardware Contents.............................................................................................................. 4 Preparation .......................................................................................................................... 4 Safety Information .............................................................................
PACKAGE CONTENTS C A D B W U V T E H F I G S J K R L Q P M O PART A B C D E F G H I J K L DESCRIPTION QUANTITY Side Shelf 2 Lid and Firebox Assembly 1 Lid Handle Assembly 1 Smoke Stack Assembly 1 Charcoal Access Door 1 Crank Handle 1 Damper Handle – Right 1 Damper 2 Side Shelf Support – Right 2 Rear/Left Front Ash Tray 1 Ash Tray Handle 1 Cart Brace 2 N PART M N O P Q R S T U V W DESCRIPTION Right Leg Assembly Caster Storage Basket Axle Wheel Left Leg Assembly Charcoal Tray Grate Warming Rac
HARDWARE CONTENTS (shown actual size) AA BB CC DD EE M6x12 Bolt Qty. 27 M6x20 Bolt Qty. 14 M5 Shoulder Bolt Qty. 8 M8 Washer Qty. 2 M8 Nut Qty. 2 FF GG HH II LL M6 Lock Nut Qty. 3 Cotter Pin Qty. 7 JJ M6x30 Bolt Qty. 2 KK Wheel Axle Sleeve Qty. 2 Hinge Bolt Qty. 2 M5 Lock Nut Qty. 8 Wrench Qty. 1 SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install the product.
SAFETY INFORMATION 8VH FDXWLRQ ZKHQ OLIWLQJ DQG PRYLQJ WKH XQLW WR DYRLG EDFN VWUDLQ RU EDFN LQMXU\ 'R QRW PRYH WKH unit while it is in use. DO NOT RSHUDWH WKH XQLW QHDU RU XQGHU ÀDPPDEOH RU FRPEXVWLEOH PDWHULDOV VXFK DV GHFNV SRUFKHV or carports. A minimum clearance of 36 in. is recommended. DO NOT operate the unit under overhead construction. $ PLQLPXP FOHDUDQFH WR FRPEXVWLEOH FRQVWUXFWLRQ LV LQ IURP VLGHV DQG EDFN DO NOT use this appliance as a heater.
ASSEMBLY INSTRUCTIONS 1. Insert axle (P) into left leg assembly (R). Attach one wheel (Q) to each side of axle (P) using one wheel axle sleeve (GG), one M8 washer (DD), and one M8 nut (EE). 1 EE DD R Hardware Used 2 1 GG Wheel axle sleeve x2 1 GG 2 DD M8 Washer P x2 Q EE M8 Nut x2 2 1 2. Attach two casters (N) to right leg assembly (M) and secure with wrench (KK). KK N 2 1 M Hardware Used KK Wrench (not to scale) x1 3.
ASSEMBLY INSTRUCTIONS 4. Attach two cart braces (L) to right leg assembly (M) using two M6x12 bolts (AA) on each side. 4 2 Hardware Used AA M6x12 Bolt x4 1 L M 1 AA 5. Attach storage basket (O) to cart braces (L). 5 O NOTE: Make sure four hooks on storage basket (O) are fully inserted into holes on cart braces (L). L 6. With the help of a second person, set lid and ¿UHER[ DVVHPEO\ % RQ WRS RI OHIW OHJ assembly (R) and right leg assembly (M). 6 B R M Lowes.
ASSEMBLY INSTRUCTIONS 6 HFXUH OLG DQG ¿UHER[ DVVHPEO\ % RQ WRS RI left leg assembly (R) and right leg assembly (M) using six M6x12 bolts (BB). 7 B BB Hardware Used BB M6x20 Bolt x6 R M $WWDFK GDPSHU + WR LQVLGH RI OLG DQG ¿UHER[ assembly (B) using four M5 shoulder bolts (CC) and four M5 lock nuts (JJ). Repeat for remaining damper (H).
ASSEMBLY INSTRUCTIONS 10. Attach ash tray handle (K) to ash tray (J) using two M6x12 bolts (AA). 10 1 K AA Hardware Used AA M6x12 Bolt x2 J 2 11. Insert damper handle – right (G) into the two holes on right side damper (H). Secure with two cotter pins (FF). Repeat for damper handle – left (V). 11 H 2 FF Hardware Used FF Cotter Pin 1 2 x4 G G 12.
ASSEMBLY INSTRUCTIONS $WWDFK ULJKW VLGH VKHOI $ WR OLG DQG ¿UHER[ assembly (B) using four M6x20 bolts (BB). Repeat on left side with remaining side shelf (A). 13 BB B A 1 NOTE: First secure two upper M6x20 bolts (BB), then lower M6x20 bolts (BB). Hardware Used BB M6x20 Bolt x8 ,QVHUW DVK WUD\ - LQWR OLG DQG ¿UHER[ assembly (B). 2 14 B J 15. Attach smoke stack assembly (D) to lid and ¿UHER[ DVVHPEO\ % XVLQJ WKUHH 0 [ EROWV (AA) and three M6 lock nuts (II).
ASSEMBLY INSTRUCTIONS $WWDFK OLG KDQGOH DVVHPEO\ & WR OLG DQG ¿UHER[ assembly (B) using two M6x12 bolts (AA). 16 C 1 Hardware Used AA M6x12 Bolt B AA x2 2 7KUHDG FUDQN KDQGOH ) LQWR OLG DQG ¿UHER[ assembly (B). Secure with one cotter pin (FF). 17 2 Hardware Used 1 FF Cotter Pin x1 B FF F 3 18. Attach charcoal tray (S) to inside of lid and ¿UHER[ DVVHPEO\ % XVLQJ IRXU 0 [ EROWV (AA). 18 2 AA Hardware Used AA M6x12 Bolt x4 1 S Lowes.
ASSEMBLY INSTRUCTIONS 19. Place one grate (T) onto the far left side of grate IUDPH LQVLGH WKH OLG DQG ¿UHER[ DVVHPEO\ % Slide to center of grill. 19 T B 2 1 20. Place a second grate (T) on the lower grate IUDPH RI WKH OLG DQG ¿UHER[ DVVHPEO\ % IDU left side). Place the third grate (T) on the upper JUDWH IUDPH RI WKH OLG DQG ¿UHER[ DVVHPEO\ % as shown. 20 T B 1 2 21.
ASSEMBLY INSTRUCTIONS 22. Insert one end of warming rack (U) onto M6x30 EROW // DQG LQWR WKH KROH RQ OLG DQG ¿UHER[ assembly (B). Repeat for other side. 22 LL B U 23. Fully tighten M6x30 bolts (LL) on each side of lid DQG ¿UHER[ DVVHPEO\ % LL 23 B Lowes.
OPERATING INSTRUCTIONS DANGER CARBON MONOXIDE HAZARD. Burning charcoal inside can kill you. It gives off carbon monoxide, which has no odor. NEVER burn charcoal inside homes, vehicles or tents. 7KLV JULOO KDV DQ DGMXVWDEOH FKDUFRDO WUD\ %\ WXUQLQJ WKH FUDQN KDQGOH WKH FKDUFRDO WUD\ FDQ EH UDLVHG or lowered to desired height. This allows for different heat settings depending on the food you are cooking and the temperature at which you want to cook.
OPERATING INSTRUCTIONS Rust can appear on the inside of your grill. Maintaining a light coating of vegetable oil on interior surfaces will aid in the protection of your grill. Exterior surfaces of the grill may need occasional touch up. We recommend the use of commercially available black high temperature spray paint. NEVER PAINT THE INTERIOR OF THE UNIT! Operating The Front Door, Dampers, And Smoke Stack WARNING: These metal parts could be very hot while grilling.
CARE AND MAINTENANCE Grill Maintenance Frequency of cleaning is determined by how often the grill is used. Make sure coals are completely extinguished and the grates are cooled down before cleaning inside of the unit. To remove the stains on the lid and front panel caused by fumigation while grilling, use of a cleaning pad is recommended. Wipe out the interior of unit with a cloth or paper towel. Clean the grates with warm water and pat dry. The coating is fragile. Do not knock, hit or drop the grates.
REPLACEMENT PARTS LIST For replacement parts, call our customer service department at 1-800-963-0211, 8:00 a.m. – 6:00 p.m. EST, Monday – Thursday, 8:00 a.m. – 5:00 p.m. EST, Friday. PART DESCRIPTION N/A Hardware pack N/A 2ZQHU¶V LQVWUXFWLRQ 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 manual Smoke stack-stainless steel Lid assembly – WITHOUT handle, temperature gauge, temperature bezel, smoke stack, Master Forge badge.
REPLACEMENT PARTS LIST For replacement parts, call our customer service department at 1-800-963-0211, 8:00 a.m. – 6:00 p.m. EST, Monday – Thursday, 8:00 a.m. – 5:00 p.m. EST, Friday. 3 1 33 7 2 5 6 4 40 12 17 32 20 8 19 10 21 11 26 15 16 13 14 18 9 27 28 22 29 24 30 25 34 35 38 36 37 31 39 23 Printed in China Master Forge & M Design® are registered trademarks of LF, LLC. All rights reserved. Lowes.
