Instruction manual
19
lowes.com/masterforge
®
INSTALLATION INSTRUCTIONS
2. When connecting the regulator/burner valve assembly to the tank valve, turn the large plastic
nut clockwise until it stops.
4. HAND TIGHTEN ONLY.
b. Hand Disassembly
1. Make certain the tank valve and all the appliances valves are in the “OFF” position.
2. Turn the large plastic nut counterclockwise until it is disassembled.
3. HAND LOOSEN ONLY.
c. Excess Flow Control
surge of pressure will cause the device to activate. The device will remain closed until the pressure is
1. Make sure all burner valves are “OFF”.
2. Open the tank valve and wait 5 seconds.
d. Temperature-Activated Shut-Off
The large plastic nut on the regulator assembly is designed in coordination with a check valve in the
propane tank. Never attempt to use damaged equipment.
IMPORTANT: Before using a fresh tank of gas, please check leakage around the connections
according to section “Checking Gas Leaks” on page 23 and make sure there is no leakage or
vapor accumulation in the cabinet. Make sure all opening around side walls are not blocked.
IMPORTANT: Place dust cap on cylinder valve outlet whenever the cylinder is not in use.
Only install the type of dust cap on the cylinder valve outlet that is provided with the cylinder
valve. Other types of caps or plugs may result in leakage of propane.
Gas Requirements
The grill is set and tested at the factory for use with LP gas only. The rating plate is located on the
inside panel of the left door.