Installation Guide

24
Lowes.com/masterforge
®
OPERATING INSTRUCTIONS
Checking Gas Leaks
Before operating your grill, after refueling, check carefully to be certain that all connections
are tight and there are no gas leaks.
1. Make 2-3 ounces of leak solution by mixing liquid dishwashing soap with water.
2. Make certain all control knobs are in the “OFF” position.
3. Brush small amounts of the leak solution on all the ttings and turn the gas on.
4. If bubbles appear, there is a leak. Proceed to step 5.
5. Turn the gas off and tighten all connections.
6. Go back to step 1 to retest the ttings.
7. If bubbles continue to appear, turn the gas off. Contact customer service.
WARNING: Never use a match or open ame for leak detection. Use of an open ame
could result in a re, explosion and bodily harm.
IMPORTANT: When connecting or replacing any gas pipe or ttings, all joints must be
sealed with approved leak-proof sealing compound or plumber’s tape.
Grill Lighting Instructions
To Light the Burners
1 . Make sure the control knobs are in the “OFF” position.
2 . Open the grill hood.
3 . Check the ignition pin position and distance between the pin
and the burner. Refer to Step 15 of the Assembly instructions.
4 . Make sure the drip tray is installed.
5 . Open the LPG tank.
6 . Light each burner separately.Turning on two burner valves
together could trip the ow limiting device in the tank
connection (LP grills only).
7 . Push the control knob in and turn the knob to the left to “HIGH”
position. Keep pressing the ignition button until the burner is lit.
8 . If the burner does not ignite within 5 seconds, immediately turn the control knob back to the
“OFF” position. Wait 5 minutes and repeat Step 7 up to 2 or 3 times.
9 . If the burner still does not ignite,TURN OFF THE GAS. WAIT 5 MINUTES for excess gas
to dissipate. Repeat Steps 6 and 7 (if necessary).
10 . If the burner still can’t be lit, use match to light. See Match Lighting Instructions.