Installation Guide

15
Lowes.com/masterforge
®
ASSEMBLY INSTRUCTIONS
15. Check the distance between the
ignition pin and the burner ports
If the distance between the ignition pin and
the burner ports is not the same as
illustrated, loosen the ignition pin screws,
adjust the distance and then re-tighten the
screws.
16. Install knob
Install three knobs (M) onto the
valve stems on rebox and hood
assembly (A) and one knob (M) onto
the valve stem on left side burner
table (H) and tighten them. Make
sure all knobs are positioned to OFF.
17. Install heat tent
Insert heat tents (C) over each burner
inside the rebox and hood assembly
(A). Direct the tabbed end of heat
tent (C) toward front of grill,
observing slots in front of rebox
and hood assembly (A) that align
with tabs on heat tent (C). Insert tabs
into slots in rebox and hood
assembly (A). Allow back side of
heat tent (C) to rest on the V-shaped
support mounted on the back
side of the rebox and hood
assembly (A).