User Guide

18
NATURAL GAS CONVERSION
24. Remove the 3 main burner control knobs
by grasping and pulling out. Insert the supplied
slotted screwdriver (KK) into the hole of each
main burner control valve stem as shown.
Rotate the stem counterclockwise (to the left)
as far as it will go. The stem will now be set in
the NG position.
Reattach the control knobs.
Hardware Used
25. Use the 17 x 19 mm wrench (FF) to
remove the LP hose and regulator from
the manifold. Then attach the NG hose
(Sold Separately) and tighten up with the
wrench.
Hardware Used
x 1
x 1
LP hose & Regulator
24.1
17 x 19 mm Wrench
FF
25
10 ft. Natural Gas Hose
(Sold Separately)
10 ft. Natural Gas Hose
24.2
Slotted
screwdriver
KK
x 1