Installation Guide

17
NATURAL GAS CONVERSION
9. Remove the 3 main burner control knobs
by grasping and pulling out. Insert the
supplied slotted screwdriver (JJ) into the hole
of each main burner control valve stem as
shown. Rotate the stem counterclockwise
(to the left) as far as it will go. The stem
will now be set in the NG position.
Reattach the control knobs.
Hardware Used
x 1
10. Use the 17 x 19 mm wrench (GG) to
remove the LP hose and regulator from
the manifold. Attach the Natural Gas
Hose (sold separately) and tighten it with
the wrench.
Hardware Used
x 1
x 1
LP hose & Regulator
Slotted
screwdriver
JJ
9.1
10
17 x 19 mm Wrench
GG
10 ft. Natural Gas Hose
(Sold separately)
10 ft. Natural Gas Hose
9.2