Installation Guide

17
NATURAL GAS CONVERSION
9. Pull off the control knob of the 3 main
burners. Use the Phillips screwdriver
(DD) to attach the conversion screw (EE)
to the back of the knobs. Re-install all
the knobs.
The conversion screw must be
attached properly. Failure to tighten
the screw will result in improper
operation.
Hardware Used
x 1
x 3
10. Use the 17 x 19 mm wrench (GG) to
remove the LP hose and regulator from
the manifold. Attach the Natural Gas
Hose (sold separately) and tighten it with
the wrench.
Hardware Used
x 1
x 1
LP hose & Regulator
Phillips
Screwdriver
DD
Conversion Screw
EE
9
10
17 x 19 mm Wrench
GG
EE
10 ft. Natural Gas Hose
(Sold separately)
10 ft. Natural Gas Hose