Installation Guide

15
NATURAL GAS CONVERSION
3. Adjust the air shutters of the main
burners by loosening the air shutter
screws with the Phillips screwdriver
(DD).
Hardware Used
x 1
4. Remove the LP orifices of all the main
burners with the orifice removal tool (CC)
and install theΦ1.45mm orifices (FF).
Hardware Used
x 1
x 3
5. Remove the 6 screws at the back of
burner box with the Phillips screwdriver
(DD). Detach the rotisserie burner cover
from the rear panel of burner box.
During this step, keep a firm hold on the
rear burner cover. Otherwise, it will drop
and may break, possibly causing injury.
Hardware Used
x 1
Phillips
Screwdriver
DD
Orifice
Removal Tool
CC
FF
Φ1.45mm Orifice
Phillips
Screwdriver
DD
3
5
Rear Burner
Cover
4
CC
FF