Owner`s manual

7
Fig.1
4
3
2
1
6
5
7
8
9
On/Off trigger switch. To turn tool on, press the trigger switch. To turn the
tool off, release the trigger switch.
Forward/Reverse switch. The forward/reverse switch should only be
operated when the motor is NOT running.
Screwdriver bit collet. To hold 1/4" bits, bit holder, and socket adaptor should
be a separate line.
Worklight. For low-light situations.
LED Forward/Reverse Indicator. Use “Forward” for driving screws,
“Reverse” for removing screws.
Work light switch. Push the switch to ‘|’ position to turn the light on; push
back the switch to ‘O’ position to turn it off.
Charging socket.
Insert the jack from the power unit to charge the driver. Tool should be
charged for 3–5 hours for optimum performance.
TO CHARGE (SEE FIG.1)
Make sure your screwdriver has completely stopped before attempting to
charge it. Insert the power unit jack into charging socket, making sure they
are properly connected.
Power unit can be used with normal house voltage of 120 volts, 60 Hz, AC
only. Connect the power unit to the power supply.
During the charge, the Reverse indicator (red light) will turn on, after fully
charged, the Forward indicator (green light) will turn on.
After normal usage, the battery requires approximately 3-5 hours charging
time to reach full capacity.