Technical data

Operation (continued)
Angle cutting (bevel cutting) (Fig. 22)
1. Layout or secure design to workpiece.
2. Move the blade guard foot to the highest position by loosening
the height adjustment knob (1). Retighten.
3. Tilt the table to the desired angle by loosening the table bevel
lock handle (2) and moving the table to the proper angle using
the degree scale and the pointer (3).
4. Tighten the table bevel lock handle (2).
5. Loosen the blade guard screw, and tilt the blade guard to the
same angle as the table. Retighten the blade guard screw. See
Hold down clamp adjustment'.
6. Position the workpiece on the right side of the blade. Lower the
blade guard foot against the surface by loosening the height
adjustment knob. Retighten.
7. Follow steps 5-7 under Freehand cutting.
nterior cutting (Fig. 23)
sign on the workpiece. Drill a 1/4" hole in the
hole in the
iece.
from the blade holder. Remove the workpiece from the table.
I
1. Lay out the de
workpiece.
2. Remove the blade. See Blade removal and installation.
3. Place the workpiece on the saw table with the
workpiece over the access hole in the table.
4. Install a blade through the hole in the workp
5. Follow steps 3-7, under Freehand cutting.
6. When finished making the interior scroll cuts simply turn the
scroll saw OFF. Unplug the saw before removing the blade
240-0041 [phone] 19