Instructions / Assembly

7. Wiring… Always disconnect power supply before
wiring the ventilator into an existing circuit. Remove
the cover on the QuickConnect
TM
Controller and mount
the metal enclosure on a rafter or stud utilizing the
pre-punched holes in the orientation as shown in
Figure 4a (below). Ensure that the TOP on the
QuickConnect QuickConnect
TM
Controller label points towards the roof.
Each ventilator must have its own QuickConnect
TM
Controller. Leave the flexible conduit with some slack and
begin wiring the QuickConnect
TM
Controller as shown in
Figure 4a (below).
Note:
The included QuickConnect
TM
Controller
arrives with factory default settings of temperature
at 105°F and humidity at 50%. These default at 105°F and humidity at 50%. These default
settings can be adjusted once the unit has been
wired and you have downloaded the app and
accepted the end user agreement.