Instructions / Assembly

or email [e-mail].
5. Wiring… Always disconnect power supply before wiring the
ventilator into an existing circuit. Remove the cover on the
QuickConnect
TM
Controller and mount the metal enclosure on a
rafter or stud utilizing the pre-punched holes in the orientation
as shown in Figure 4a (below). Ensure that the TOP on the
QuickConnect
TM
Controller label points towards the roof. Each
ventilator must have its own QuickConnect ventilator must have its own QuickConnect
TM
Controller. Leave
the flexible conduit with some slack and begin wiring the
QuickConnect
TM
Controller as shown in Figure 4a (below). The
included QuickConnect
TM
Controller arrives with factory default
settings of temperature at 105°F and humidity at 50%. These
default settings can be adjusted once the unit has been wired
and you have downloaded the app and accepted the end user
agreement. agreement.