REPLACING SWITCH Step 1. Remove the screw at the bottom of the front cover, then unscrew the front part. Step 2. Remove the filter set. Step 3. Remove the screw from the bottom housing, then lift up the upper housing.
Step 4. Use the screw-driver to pry up the knob. knob Screw-driver Step 5. Remove the screw of the switch, then take down the switch. switch screw Step 6. Remove 2 screws of the connecters of the voltage adjuster.
Step 7. Solder the wire of the switch. Step 8. Replace the new switch. The connecters 3 and 4 of the voltage adjuster connect with the wire of the switch. switch Step 9. Put the switch into the upper housing and replace the screw.
Step 10. Re-assemble the dryer in reverse order.
