Operating instructions

INTRODUCTION
Evaporative cooling works on the principle of heat absorption by moisture evaporation. Simply put, heat is removed
from the air as water evaporates. You feel this principle in action when you step out of a swimming pool or shower and
feel immediately cooler as water evaporates from the surface of your skin.
Your evaporative cooler works on the same principle. Hot outside air is pulled through water-saturated pads, where the
air is cooled by evaporation and then discharged from the cooler.
WARNINGS AND SAFETY RULES
WARNING…
To reduce the risk of electric shock, fire or injury:
• Read instructions and labels carefully.
• Always unplug the electric cord to your cooler before you work on the cooler.
• Your cooler will run on 120 Volt AC, 60 Hz (cycle) current only.
• Plug into three-prong grounded GFCI protected electrical receptacle only.
• Do not operate if plug or cord are damaged in any way.
• Do not step on or roll over power cord with heavy or sharp objects.
• Do not operate unit unless all panels are securely in place.
• Remove the plug from the electrical receptacle by pulling on the plug and not the cord.
• Test the GFCI receptacle or breaker monthly to ensure it is functioning properly.
• Do not operate near open containers of flammable liquids or gases.
• Never wash your cooler cabinet with a garden hose; water may harm the motor and pump.
• If the unit is damaged or it malfunctions, do not continue to operate it. Refer to the warranty or troubleshooting
section, www.MobileMasterCool.com or call AdobeAir customer service department at [phone].
MOBILE MASTERCOOL OWNER’S GUIDE
MODEL MMB10 • MMB12 • MMB14 • MMB16 • MMPC12
2
AP059430 January 2005