Specifications

6
LIGHTING
THE BARBECUE
Prior to lighting your barbeque, visually check all hoses before each use, for nicks,
cracking, abrasions or cuts. If the hose is found to be damaged in any way, do not
use your barbeque. A replacement hose and regulator is required.
•
Make sure you have followed all the checks, procedures and instructions
in all previous sections before attempting to light the barbecue.
Important
•
Always raise the barbeque lid before lighting the burner.
•
Do not lean over the barbeque when lighting in case of back flash.
•
Making sure the main barbecue control knobs are off,
slowly and carefully open the propane gas cylinder valve.
•
Visually check the flames every time you light your barbeque. If the flame
is abnormally small or smokey yellow – shut off the barbeque and check
the venturi tubes for blockage or refer to the Troubleshooting Guide.
Using The Igniter To Light The Burner
Ensure burner control knobs in the off position before opening gas supply.
1. Open the lid before lighting.
2. Open the gas supply valve and wait 5 seconds.
3. Push in and turn a single main burner control knob to ‘HIGH’.
4. Depress the igniter until a click noise is heard.
5. If the burner does not light immediately (within four seconds),
turn burner control knob off and wait 5 minutes to clear the gas.
6. Repeat steps 1 to 5. If burner still fails to light, refer to the
Troubleshooting Guide to determine the cause and solution,
or try the Match Lighting procedure below.
CAUTION
If ignition does NOT occur in 5 seconds, turn the burner
controls OFF, wait 5 minutes and repeat the lighting procedure.
If the burner does not ignite with the valve open,
gas will continue to flow out of the burner and could accidently
ignite with risk of injury.