Specifications

20
11
Place the firebox + top lid onto burner box supporting bars
(DI & DJ) using hardware #1, #4, and #13 (x4), from the
inside of the firebox as shown.
Connect the electrode wire to the igniter (CC) as shown.
Install hardware #2, #4, and #13 (x4) into both sides of
burner box to be used to support the flame tamer. Insert the
flame tamer (BC) as shown. Attention: When assembling
the Lid Handle (AB) to the Top Lid (AA), you must use 2
pieces of Hardware #12 (x4), on the inside and the outside,
as well as #5 (x2), as shown.
Very Important
Burner venture tubes must engage valve openings. Make
sure that the valves are aligned with the burner tubes.
Ignitor
Wire
Burner Tube
Valve