User Manual

TF2047903-MC-00-ENG Page 7 of 21 20161205 V.2
 Always close LP tank valve and remove coupling nut before moving LP tank from
specified operating position.
 Appliance must not be used for commercial cooking.
 This appliance will be hot during and after use. Use insulated oven mitts or gloves
for protection from hot surfaces or splatter from cooking liquids.
 Avoid bumping or otherwise impacting the appliance to prevent spillage or
splashing of hot cooking liquid.
 Never drop food or accessories into hot cooking liquid. Lower food and
accessories slowly into the cooking liquid in order to prevent splashing or
overflow. When removing food from the appliance care should be taken to avoid
burns from hot cooking liquids.
DANGER
 The safety relief valve on the LP tank could activate releasing gas and cause an
intense fire with risk of death or serious injury. Therefore, follow instructions below
exactly.
 Do not store a spare LP-gas cylinder under or near this appliance.
 Never fill the cylinder beyond 80 percent full.
 If you see, smell, or hear escaping gas, immediately get away from the LP
tank/appliance and call your fire department.
LP Tank Removal, Transport and Storage
 Turn OFF all control knobs and LP tank valve. Turn coupling nut counter-clockwise by
hand only – do not use tools to disconnect. Failure to install safety cap as directed
may result in serious personal injury and/or property damage.
 A disconnected LP tank in storage or being transported
must have a safety cap installed (as shown). Do not
store an LP tank in enclosed spaces such as a carport,
garage, porch, covered patio or other building. Never
leave an LP tank inside a vehicle which may become
overheated by the sun.
 Do not store LP tanks in an area where children play.
 Turn off gas at supply cylinder when not in use.
LP Tank
The LP tank used with your appliance must meet the following requirements:
 Purchase LP tanks only with these required measurements: 12” (30.5 cm) width x 18”
(45.7 cm) height with 20 lb (9 kg) maximum capacity.
 The LP-gas supply cylinder to be used must be constructed and marked in
accordance with the specifications for LP-gas cylinders of the US Department of
Transportation (DOT) or the Canadian standard, CAN/CSA-B339, Cylinders, Spheres
and Tubes for the Transportation of Dangerous Goods.